How To Manually Install Drivers Windows Xp

This version (18 January 2022 04:30) was approved past Nitzan Gadish.

How to Install Drivers (Without an Installer)

This page describes how to install drivers without an installer, as in the case of the ADXL362 Datalogger / Evolution Lath.

Employ the Table of Contents on the correct to scroll to instructions for your operating arrangement.
Notation that your organization may deport slightly differently, only the overall procedure remains the same.

Windows vii

Connect the board to your estimator via a USB cable.
If prompted to install drivers, choose Install from a list or specific location (Avant-garde), and so click Side by side. If no prompt appears, find the device in your computer's Device Manager:
1. Click the Windows push in the bottom left corner of the screen to open up the Starting time menu.
2. Correct-click on My Figurer, and select Manage. In the alarm screen that comes up, click Yes.
3. In the window that opens, select the Device Director from the list on the left-manus side.
4. The board will show up in the Device Manager as an Unknown Device. (If information technology shows upward under Ports (COM & LPT) with a valid COM port, this ways the drivers accept already been installed and are working properly.)
5. Right-click on the Unknown Device and select Update Commuter Installation…. Follow the remaining instructions beneath.
Select Permit me pick…, then click Next.
Select Bear witness All Devices, and click Next.
Click Have Disk….
On the screen that opens, select Browse…
Navigate to the .inf file on your hard drive or CD.
Click Open, then in the Install From Disk prompt, click OK.
Select "ADI Inertial Sensor Evolution Lath" in the Model list, and click Next >.
Respond Go along Anyway or Install to the warning.
Click Shut to consummate the USB driver installation.

Windows XP

Connect the board to your estimator via a USB cable.
When prompted to install drivers, cull Install from a list or specific location (Advanced), then click Next.
Select Don't search. I will choose the driver to install, so click Next.
Select Ports (COM & LPT), and click Side by side.
Click Have Deejay….
On the screen that opens, select Scan….
Navigate to the .inf file on your hard drive or CD and click Open.
Click Open, then in the Install From Disk prompt, click OK.
Select "ADI Inertial Sensor Evolution Board" in the Model list, and click Next >.
Respond Continue Anyway to the warning.
Click Finish to complete the USB commuter installation.